FBIhere
4749
48
19
It's just a Hi Point carbine in the new bullpup stock from High Tower Armory. I've never owned a PCC, or anything in 9mm before, but man, does it handle so much better than the hour I had it in the original stock.
And after adjusting the trigger a little, double taps are super easy, with little to no over travel on the initial pull.
Crippling
not a huge fan of guns. but thats a nice gun
iatha
LurkingSarcasm
I found that when I asked them to purchase a black knuckle guard they sent me one for free
918benjamin
How did you adjust trigger? I just bought one
FBIhere
2 You want to adjust it so it breaks early in the pull, but not so early that it doesn't reset when you release.
FBIhere
There are two small allen screws in the trigger linkage. One adjusts the amount of takeup the linkage puts onto the trigger on the receiver.
CotterPyke
looks cool. Any jams yet?
FBIhere
Nope, just some short stroking when charging on a fresh mag. As soon as I got a round chambered, it ran flawlessly.
PirateLogic
I'm sure enough short stroking would eventually clear out any jams. Might make a bit of a mess tho. Long strokes would make it faster...
CotterPyke
noice!
darkunited
Wouldn't that be considered a SBR? My pistol carbine is Similar in size and i use a "brace".
vanski87
Not if the the barrel is 16inches long which seems to be the case considering it’s a bullpup
FBIhere
At least 16” total barrel length with at least 26" Overall Length of the rifle. This has a 16.5” barrel with 26.25” OAL. It's about as short
FBIhere
as you can get without an SBR (and even that would have to be a bullpup to be this short, unless you have something crazy like a 3” barrel)
HeyItsJP
Didn't know Hi Point even made rifles. After owning one of their pistols, can't say I'm willing to try one either. How is it?
FBIhere
It works well, which for a $250 gun, is about as much as I can ask for. I only put about 100 rounds through it, and the only problems I had
FBIhere
were probably my fault. I would charge the rifle on a fresh magazine, and pull the trigger, to find that I hadn't chambered a round. However
FBIhere
, every time I took the time to watch the ejection port while charging, it chambered just fine, so I think I was just short stroking it.
HeyItsJP
Might have to look it up. I like the stock you put on it. Good stuff!
FBIhere
Fair warning, the original stock is a bitch and a half to get off, even for routine maintenance, requiring a special tool that comes with it